Removing And Installing Accelerator Pedal Module (Yeti) - Skoda Octavia III 2013 Workshop Manual

Disconnect connector 8K0 973 706
– Pull piston slide valve -A- (red) upwards in direction of arrow
-1- up to the stop.
– Press the piston slide valve in direction of arrow -2- and dis‐
connect the socket housing -B- in direction of arrow -3-.
The piston slide valve -A- remains in the top position.
Fit on connector 8K0 973 706
– Push the socket housing -B- down in direction of arrow -1- up
to the stop.
– Lightly press the piston slide valve in direction of arrow -2- and
slide in the direction of arrow -3-.
The piston slide valve -A- can only be pushed downwards if
the socket housing was pushed downwards »up to the stop«.
– For safety reasons, check the connector for secure catch by
tightening it in the opposite direction.
3.4 Removing and installing accelerator
pedal module (Yeti)
⇒ "3.4.1 Remove and fit on connector for accelerator pedal mod‐
ule (Yeti)", page 224
Special tools and workshop equipment required
♦ Release tool - T10238- (for left-hand drive vehicle)
♦ Release tool - T10240- (for right-hand drive vehicle)
Removing
– Remove steering column cover -arrows-.
– Lever out the cap Pos. 4
– Release fixing screw Pos. 3
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
⇒ page 221 with a screwdriver.
⇒ page 221 .
1.6/81 kW MPI engine - Edition 06.2014
223
3. Accelerator pedal