Skoda Octavia III 2013 Workshop Manual page 139

Continued for all vehicles
– Loosen the screws in the sequence -19...1- and unscrew
them.
– Loosing oil sump top part carefully from the bonding.
– Remove baffle.
Install
Note
Replace screws which have been tightened firmly to a torqueing
angle.
– Check oil channels in the oil sump top part and in the cylinder
block for contamination.
WARNING
Wear protective gloves when working with sealant and grease
remover!
– Remove the remaining sealant on the cylinder block and on
the oil pan with chemical sealant remover.
– Degrease the sealing surfaces.
Note
Pay attention to the use by date on sealant.
♦
♦ The oil pan must be installed within 5 minutes after applying
the sealant.
The oil pan can be better and more securely installed if 2 M6
♦
threaded pins are screwed on the flange of the cylinder block
for the insertion.
– Cut off nozzle tube at the front marking (∅ of nozzle approx.
2 mm).
Caution
Risk of blockage of the lubrication system through excess seal‐
ant.
♦ Do not apply a thicker sealant bead than indicated.
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
1. Lubrication system
133