Skoda Octavia III 2013 Workshop Manual page 126

Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
– Pull in -T10478/1A- with the screw -T10478/5- to the stop.
– Fit the timing belt (set timings)
3.4.3 Removing and installing the exhaust
camshaft on the gearbox side
Special tools and workshop equipment required
♦ Assembly tool - T10479-
♦ Extractor tool - T20143/1-
Removing
– Remove the toothed belt gear for coolant pump drive
⇒ page 159 .
– Carefully fit extractor hook -T20143/1- between camshaft and
seal -1-.
– Lever out the gasket ring.
Install
Note
Do not oil new sealing ring.
– Push sealing ring -1- over the receiver tube -T10479/3- onto
the guide bushing -T10479/2- .
• Fitting position: Closed side of sealing ring points to the re‐
ceiver tube.
– Disconnect receiver tube and guide bushing.
120
Rep. gr.15 - Cylinder head, valve gear
⇒ page 91 .