Skoda Octavia III 2013 Workshop Manual page 228

Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
– Disconnect plug connection -2- at the accelerator pedal mod‐
ule ⇒ page 222 .
– Release screw -1-.
– Remove accelerator module -3- from the uptake.
Install
Installation is carried out in the reverse order.
On vehicles with automatic transmission, adapt the engine control
unit after replacing the gas pedal module.
Tightening torques
♦ Screw for gas pedal module.
⇒ "3.1 Accelerator pedal module- Summary of components
(Octavia III)", page 220
3.3.1 Remove and fit on connector for accel‐
erator pedal module (Octavia III)
Note
The plugs for the accelerator pedal module which are inserted,
must be disconnected and fit on in a different manner.
Disconnect connector 1K0 973 706
– Slightly press the piston slide valve -A- (grey) in direction of
arrow -1- and push it up to the stop in direction of arrow -2-.
– Hold the piston slide valve in this position and disconnect the
socket housing -B- towards the top in direction of arrow -3-.
The piston slide valve -A- remains in the bottom position.
Fit on connector 1K0 973 706
– Push the socket housing -B- down in -direction of arrow- until
the housing can be heard to lock in place.
The piston slide valve -A- moves automatically upwards.
– For safety reasons, check the connector for secure catch by
tightening it in the opposite direction.
222
Rep. gr.20 - Fuel supply system