Skoda Octavia III 2013 Workshop Manual page 137

– At the point identified by an -arrow-, carefully lever out the oil
sump bottom part using a screwdriver.
– Remove lower part of oil sump. If necessary, undo the oil pan
by applying slight blows with a rubber-headed hammer.
Install
WARNING
Wear protective gloves when working with sealant and grease
remover!
– Remove the remaining sealant on the cylinder block and on
the oil pan with chemical sealant remover.
– Degrease the sealing surfaces.
Note
Pay attention to the use by date on sealant.
♦
The oil pan must be installed within 5 minutes after applying
♦
the sealant.
The oil pan can be better and more securely installed if 2 M6
♦
threaded pins are screwed on the sump top part for the inser‐
tion.
– Cut off nozzle tube at the front marking (∅ of nozzle approx.
3 mm).
Caution
Risk of blockage of the lubrication system through excess seal‐
ant.
♦ Do not apply a thicker sealant bead than indicated.
– Apply sealant to clean sealing surface of sump as shown.
The sealant bead must be:
♦ be 2...3 mm thick
♦ Run bead along inner side of bolt holes -arrows-
Note
Take particular care when applying sealant bead in the area
♦
of the sealing flange.
♦ After applying the sealant, the oil sump bottom part must be
installed within 5 minutes.
– Position oil sump bottom part and tighten screws.
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
1. Lubrication system
131