Removing - (Yeti) - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
– Screw out gearbox mount screws -arrows- fully.
Caution
There is a risk of damage from vacuum lines or electric cables.
♦ Check that all vacuum lines and electric cables between
engine, gearbox, assembly bracket and body have been
loosened.
♦ Guide the engine/gearbox unit out of the engine compart‐
ment carefully when lowering.
– Drain engine/gearbox unit a little.
– Push the gearbox side of the engine/gearbox unit forwards
and drain it slowly and carefully.
– Remove the gearbox from the engine ⇒ gearbox; Rep. gr.
34 .
1.2

Removing - (Yeti)

Special tools and workshop equipment required
♦ Removal tool for inner lining of the door panel - MP8-602/1-
♦ Extending the lifting device - MP9-201 (2024A)-
♦ Engine/gearbox jack - V.A.G 1383 A-
♦ Engine bracket - T10497-
♦ Catch pan , e.g. -VAS 6208-
♦ Hose clip pliers, e.g. - VAS 6362-
♦ Locking pin - T10060 A-
♦ Double ladder , e. g. -VAS 5085-
♦ Grease - G 000 100-
♦ Protective goggles
♦ Protective gloves
Note
The engine is removed downwards together with the gearbox.
♦
♦ All cable straps that have been loosened or cut open when the
engine was removed must be attached again in the same lo‐
cation when the engine is installed again.
Leave the ignition key in the ignition lock so that the steering
♦
lock does not click into place.
Collect drained coolant in a clean container for reuse or proper
♦
disposal.
18
Rep. gr.10 - Removing and installing engine