Skoda Octavia III 2013 Workshop Manual page 28

Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
– Open all locking elements and fastenings for the engine wiring
harness at frame side rail -arrows-.
– Remove engine wiring harness and place on the engine.
– Disconnect all electrical lines from the gearbox, generator and
starter motor and uncover them.
– Release screws -1- and remove heat shield for right drive
shaft, if present.
– Unscrew nuts -1- for securing the exhaust pipe to the cylinder
head.
– Unscrew screws -2- for supporting the exhaust system and
strap up the exhaust system.
– Unscrew the nut -arrow- from the left track control arm - G78-
if the front left vehicle level sensor is present.
22
Rep. gr.10 - Removing and installing engine