Skoda Octavia III 2013 Workshop Manual page 100

Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
– Turn the fixing screw - T10340- up to the stop in the cylinder
block and tighten to 30 Nm.
– Turn crankshaft up to the stop in direction of rotation of engine.
Note
The crankshaft is only locked in direction of rotation of engine
using the fixing screw - T10340- .
• The crankshaft sprocket now lies on the fixing screw and the
"TCD" position is set.
• On the inlet camshaft -3- the asymmetrically arranged grooves
-1-, on the gearbox side, above the camshaft centre -2-.
• On the outlet camshaft the asymmetrically arranged grooves
-1-, on the gearbox side, above the camshaft centre -2-.
• The asymmetrically arranged grooves of the outlet camshaft
-1- are accessible via the recesses in the toothed belt gear for
the drive of the coolant pump -3-.
Note
The outlet camshaft has one symmetrically and one asymmetri‐
cally arranged pair of grooves. In the "TDC" position the asym‐
metrically arranged pair of grooves must by above the imaginary
horizontal centre line.
If the camshafts are not as described:
– Undo the positioning screw - T10340- and rotate crankshaft a
turn further in the running direction of the engine and set to
"TDC" again ⇒ page 93
If the camshafts are as described:
Note
The camshaft clamp - T10477- must slide into position easily.
♦
The camshaft clamp must not be positioned using any kind of
♦
hammer.
94
Rep. gr.15 - Cylinder head, valve gear
.