Skoda Octavia III 2013 Workshop Manual page 257

– Unscrew respective lambda probe using a spanner from the
lambda probe ring spanner set - 3337- .
1 - Lambda probe after catalytic converter - G130-
2 - Lambda probe - G39-
Install
Install in the reverse order of removal. When doing this, note the
following:
Note
New lambda probes are coated with assembly paste. This
♦
paste must not come into contact with the slots of the lambda
probe body.
For a re-used lambda probe, only coat the thread with hot bolt
♦
paste. This paste must not come into contact with the slots of
the lambda probe body. Hot bolt paste ⇒ Electronic Catalogue
of Original Parts"ETKA"
The electrical cable wire connection of the lambda probe must
♦
be secured again at the same points during installation. Con‐
tact between the electrical cable connection and the exhaust
pipe must be prevented.
Tightening torques
♦ Lambda probe
⇒ "6.1 Lambda probe - Summary of components", page 249
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
251
6. Lambda probe