Removing And Installing Oil Pump - Skoda Octavia III 2013 Workshop Manual

Oil sump top part - tightening torque and tightening order
Note
Replace screws which have been tightened firmly to a torqueing
angle.
– Tighten screws gradually in the given sequence:
Stage Bolts
1. -1...19-
1. -1...19-
2. -1...19-
Installation is carried out in the reverse order. When installing,
note the following:
Only vehicles with air conditioner
– Install AC compressor ⇒ Heating, Air Conditioning; Rep. gr.
87 .
Continued for all vehicles
– Fill with engine oil and check the oil level.
♦ ⇒ Maintenance ; Booklet Octavia III
♦ ⇒ Maintenance ; Booklet Yeti
1.4

Removing and installing oil pump

Removing
– Disconnect battery ⇒ Electrical System; Rep. gr. 27 .
– Removing toothed belt
– Remove sump top part
– Unscrew the fixing screws -arrows- and remove the tensioning
device for Poly V-belt
– Remove alternator ⇒ Electrical System; Rep. gr. 27 .
– Removing gasket ring for crankshaft on belt pulley side
⇒ page 53 .
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
Tightening torque/torqueing angle
by hand as far as the stop
8 Nm
90° (torque a further 90° (
⇒ page 102 .
⇒ page 132 .
⇒ page 49 .
1.6/81 kW MPI engine - Edition 06.2014
1
/ 4 turn)
135
1. Lubrication system