Removing And Installing Coolant Temperature Sender G62 - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
– Release the screws in the order -F...A-.
– Remove coolant pump from coolant pump housing.
– Remove thermostat -2- from coolant pump -1-.
Install
Install in the reverse order of removal. When doing this, note the
following:
Note
Replace gasket.
– Moisten gasket with coolant.
– Fit thermostat housing to coolant pump.
• The centring bolts on the thermostat must be inserted into the
guides -arrows- on the coolant pump.
– Tighten screws for thermostat housing
– Install coolant pump ⇒ page 156
– Top up coolant ⇒ page 148
Tightening torques
♦ Screws for thermostat housing
⇒ Fig. ""Tightening sequence thermostat housing at coolant
pump - tightening torque and tightening sequence"" ,
page 155
2.6 Removing and installing coolant temper‐
ature sender - G62-
Removing
• Engine cold.
– Briefly open the cap -arrow- for the coolant expansion reser‐
voir in order to remove the remaining pressure in the coolant
system, then close until it clicks into place.
– Disconnect plug connection from coolant temperature sender
- G62-
Note
Place a cloth below to absorb leaking coolant.
162
Rep. gr.19 - Cooling
⇒ page 155 .
.
.