Remove The Toothed Belt From The Camshafts - Skoda Octavia III 2013 Workshop Manual

– Insert camshaft clamp -T10477- to stop into camshafts and
tighten bolt -arrow- by hand.
If camshaft clamp - T10477- cannot be installed:
– Using the assembly tool - T10487- in -direction of arrow- press
on the toothed belt.
– At the same time, insert the camshaft clamp -T10477- up to
stop into the camshafts and fix with the screw.
If it is not possible to insert the camshaft clamp -T10477- , the
timing is NOK:
– Remove the toothed belt from the camshafts and set the tim‐
ings ⇒ page 91 .
If it is possible to insert the camshaft clamp -T10477- , the timing
is OK:
Caution
Risk of destruction of the engine.
♦ To complete the work, check to ensure that the fixing
screw - T10340- and camshaft clamp -T10477- have been
removed.
Install in the reverse order of removal. When doing this, note the
following:
Tightening torques
♦ Locking screw for bore in the cylinder block
⇒ Fig. ""Unscrew locking screw TDC bore at the cylinder block
- tightening torque"" , page 88
♦ Screw cap on the camshaft housing
⇒ "1.2 Camshaft housing - Summary of components",
page 77
♦ Screws for cover for coolant regulator
⇒ "2.1 Summary of components - coolant pump/coolant ther‐
mostat", page 153
♦ Screw for ignition coil with power output stage
⇒ "1.1 Ignition system - Summary of components",
page 269
♦ Spark plug
⇒ "1.1 Ignition system - Summary of components",
page 269
♦ Noise insulation ⇒ Body Work- Assembly; Rep. gr. 66
2.4 Remove the toothed belt from the cam‐
shafts
Special tools and workshop equipment required
Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
91
2. Toothed belt drive