Installing - (Octavia Iii) - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤ , Yeti 2010 ➤ , Yeti 2011 ➤
1.6/81 kW MPI engine - Edition 06.2014
– Suspend lifting device - MP9-201 (2024A)- from the engine
and workshop crane - VAS 6100- as shown in the illustration.
Note
For coordination with the unit centre of gravity position the perfo‐
rated rails must be placed as shown in the illustration.
WARNING
There is a risk of accident from loose parts of the lifting device.
♦ The suspension hooks and rig pin on the lifting must be
secured using plug-in locks -arrows-.
– Lift off engine with installed engine mount T10497 with work‐
shop crane - VAS 6100- from engine/gearbox jack - V.A.G
1383 A- .
– Remove engine mount T10497 .
– Secure engine with bolts -arrows- at engine and gearbox
mount - VAS 6095- as shown in the illustration.
1.4

Installing - (Octavia III)

Installation is performed in a similar way in the reverse order. Pay
attention to the following points:
– Installing intermediate plate
For vehicles with manual gearbox
– Clean the serration of the drive shaft and if the clutch disc has
been used clean the hub serration, remove existing corrosion
and only apply a very thin layer of grease - G 000 100- to the
serration of the drive shaft.
– Subsequently move the clutch disc up and down on the drive
shaft until the hub fits smoothly on the shaft. Always remove
excess grease.
– Check the centering of the clutch disc ⇒ Gearbox; Rep. gr.
30 .
– Check the clutch release bearing for wear. Replace release
bearing if worn ⇒ Gearbox; Rep. gr. 30 .
26
Rep. gr.10 - Removing and installing engine
⇒ page 57 .