Install Ac Power Supplies - Juniper PTX10016 Quick Start Manual

PTX10016 Router Quick Start Guide

Install AC Power Supplies

20
Tighten the two 10-32 screws using a Phillips screwdriver and apply torque between
7.
of 30.1 in.-lb (3.4 N-m) and 42.04 in.-lb (4.75 N-m).
Dress the grounding cable and ensure that it does not touch or block access to other
8.
device components and that it does not drape where people can trip over it.
PTX10016 power supplies are hot-insertable and are field-replaceable units (FRUs). You
can install up to 10 power supplies in a PTX10016. The power supplies install in the rear
of the chassis in the slots provided along the left side.
CAUTION: Do not mix AC and DC power supplies in the same chassis.
Before you install an AC power supply in the router, ensure that you have the following
parts and tools available to install an AC power supply in a PTX10016:
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 1
Power cords appropriate for your geographical location
Power cord retainer clips
To install an AC power supply in a PTX10016 :
Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to the ESD point on the chassis. There is an ESD point located next
to the protective earthing terminal and below
If the power supply slot has a cover panel on it, insert your thumb and forefinger into
2.
the finger holes, squeeze and pull the cover out of the slot. Save the cover panel for
later use. See Figure 17 on page
on the rear panel.
PSU 9
21.
Copyright © 2018, Juniper Networks, Inc.