Unpacking The T4000 Router - Juniper T4000 Hardware Manual

T4000 Core Router Hardware Guide

Unpacking the T4000 Router

124
Unpacking the T4000 Router on page 124
Verifying the T4000 Router Parts Received on page 125
The router is shipped in a wooden crate. A wooden pallet forms the base of the crate.
The router chassis is bolted to this pallet. Quick Start installation instructions and a
cardboard accessory box are also included in the shipping crate.
The shipping crate measures:
51 in. (129 cm) high
35 in. (89 cm) wide
43 in. (110 cm) deep
The total weight of the crate containing the router and accessories can range up to 392 lb
(178 kg).
NOTE: The router is maximally protected inside the shipping crate. Do not
unpack it until you are ready to begin installation.
To unpack the router (see
Move the shipping crate to a staging area as close to the installation site as possible,
1.
where you have enough room to remove the components from the chassis. While the
chassis is bolted to the pallet, you can use a forklift or pallet jack to move it.
Position the shipping crate with the arrows pointing up.
2.
Open all the latches on the shipping crate.
3.
Remove the front door of the shipping crate cover and set it aside.
4.
Slide the remainder of the shipping crate cover off the pallet.
5.
Remove the foam covering the top of the router.
6.
Remove the accessory box and the Quick Start documentation.
7.
Verify the parts received against the lists in
8.
Received" on page 125.
Figure 31 on page 125):
"Verifying the T4000 Router Parts
Copyright © 2018, Juniper Networks, Inc.