T4000 Core Router Hardware Guide
200
Remove the clear plastic cover protecting the terminal studs on the faceplate.
6.
NOTE:
You will replace this cover with the new cover provided in the
terminal jumper kit (model number PWR-T-BUS-BAR-S). The new cover
is labeled 2 in
Remove the nut and washer from each power terminal stud to be connected. If no
7.
washers and nuts are already installed, they should be in the accessory box.
Remove the captive screws on all three cable restraints on the right edge of the power
8.
supply faceplate (using a Phillips (+) screwdriver, number 2).
Place one terminal jumper over the negative (–) DC
9.
on the right.
NOTE:
The terminal jumpers are located in the terminal jumper kit (model
number PWR-T-BUS-BAR-S).
Figure 80: Terminal Jumper
Place a washer, and then a nut on the negative (–) DC
10.
Using a 7/16-in. (11 mm) nut driver, tighten the nut. Apply between 23 lb-in. (2.6 Nm)
and 25 lb-in. (2.8 Nm) of torque to each nut.
Figure 85 on page
205.
INPUT 0
and
INPUT 1
terminals
INPUT 0
terminal.
Copyright © 2018, Juniper Networks, Inc.