Connecting The T4000 Router To A Management Ethernet Device; Figure 64: Console And Auxiliary Ports On The Cip - Juniper T4000 Hardware Manual

T4000 Core Router Hardware Guide
Related
Documentation

Connecting the T4000 Router to a Management Ethernet Device

180

Figure 64: Console and Auxiliary Ports on the CIP

T4000 Connector Interface Panel (CIP) Description on page 14
Overview of Connecting the T4000 Router to External Devices on page 177
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet with RJ-45 connectors to the
with the router.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Turn off the power to the management device.
2.
Plug one end of the Ethernet cable
3.
the appropriate ETHERNET
port on the CIP. One cable is provided
ETHERNET
(Figure 65 on page 181
port on the CIP (see Figure 66 on page
Copyright © 2018, Juniper Networks, Inc.
shows the connector) into
181). The ports