Installing The Spacer Bars; Figure 33: Positioning The Spacer Bar On The Rack - Juniper T4000 Hardware Manual

Hide thumbs Also See for T4000:

Table of Contents

T4000 Core Router Hardware Guide

Installing the Spacer Bars

Documentation

The router is shipped with each spacer bar attached to the rear of each front-mounting

To install the spacer bars:

Remove each spacer bar by removing the screws that fasten the spacer bar to the

front-mounting flange.

Place one of the spacer bars over a flange of the large shelf. Position the notch in the

rear of the spacer bar so the upper part of the bar is flush with the rack rail and the

lower part is flush with the flange of the shelf (see

Insert a mounting screw into each of the nonthreaded holes in the recesses of the

spacer bar to secure the spacer bar. Each hole should have a cage nut behind it.

Repeat Steps

for the other spacer bar.

Tighten all the screws completely.

Rack Requirements for the T4000 Router on page 93

Installing the T4000 Mounting Hardware for an Open-Frame Rack on page 133

Figure 33 on page