Figure 118: Removing An Fpc - Juniper T4000 Hardware Manual

See Also
Copyright © 2018, Juniper Networks, Inc.
When the FPC is out of the chassis, do not hold it by the ejector handles,
bus bars, or edge connectors. They cannot support its weight.
If you are not reinstalling an FPC into the emptied FPC slot within a short time, install
11.
a blank FPC panel over the slot to maintain proper airflow in the FPC card cage.
CAUTION: After removing an FPC from the chassis, wait at least 30
seconds before reinserting it, removing an FPC from a different slot, or
inserting an FPC into a different slot.

Figure 118: Removing an FPC

T-1 60 0 FP C4
T4000 FPC Description on page 57
Chapter 30: Replacing Line Card Components
297