Figure 133: Installing A T4000 Sib - Juniper T4000 Hardware Manual

See Also
Copyright © 2018, Juniper Networks, Inc.
Issue the following CLI command on the router:
user@host> request chassis sib online slot 0
Check the LEDs on the SIB faceplate.
8.
The green OK LED should light steadily a few minutes after the SIB is installed.
If the LED is lit steadily, remove and install the SIB again. Make sure that the
FAIL
SIB is seated properly. If the
properly. Contact your customer support representative.
Verify that four SIBs are in the
9.
the status of the SIB by issuing the
user@host> show chassis sibs
Slot State
0 Spare
1 Online
2 Online
3 Online
4 Online

Figure 133: Installing a T4000 SIB

Chapter 32: Replacing Switch Fabric Components
FAIL LED still lights steadily, the SIB is not functioning
state and one SIB is in the
Online
command:
show chassis sibs
Uptime
1 day, 13 hours, 16 minutes, 49 seconds
1 day, 13 hours, 16 minutes, 33 seconds
1 day, 13 hours, 16 minutes, 16 seconds
1 day, 13 hours, 16 minutes
state. Display
Spare
321