Installing A T4000 Txp-Lcc-3D Sib; Figure 137: Removing A Txp-Lcc-3D Sib - Juniper T4000 Hardware Manual

Installing a T4000 TXP-LCC-3D SIB

Copyright © 2018, Juniper Networks, Inc.

Figure 137: Removing a TXP-LCC-3D SIB

To install a TXP-LCC-3D SIB:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
2.
ejector handles on the SIB.
Carefully align the sides of the SIB with the guides inside the chassis.
3.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned
4.
(Figure 138 on page 327).
Grasp both ejector handles, and press them inward to seat the SIB. Ensure that the
5.
ejector handle tabs are properly mated inside their corresponding chassis slots. You
might have to close and open the handles a few times before the tabs catch the slots.
Tighten the captive screws on the ejector handles.
6.
Remove the dust covers from the transceivers and cables. Store the dust covers in a
7.
dust-free resealable plastic bag.
Chapter 32: Replacing Switch Fabric Components
325