Juniper T4000 Hardware Manual page 124

T4000 Core Router Hardware Guide
94
For open-frame racks, center-mounting is preferable to front-mounting because the
more even distribution of weight provides greater stability.
The router is designed for installation in a 19-in. rack as defined in Cabinets, Racks, Panels,
and Associated Equipment (document number EIA-310-D) published by the Electronics
Components Industry Association (
With the use of adapters, the router can fit into a 600-mm-wide rack, as defined in the
four-part Equipment Engineering (EE); European Telecommunications Standard for
Equipment Practice (document numbers ETS 300 119-1 through 119-4) published by the
European Telecommunications Standards Institute (
wing devices to narrow the opening between the rails.
The rack rails must be spaced widely enough to accommodate the router chassis's
external dimensions: 37.45 in. (95.1 cm) high, 31 in. (78.7 cm) deep, and 17.43 in. (44.3 cm)
wide, excluding the front and rear cable management systems. The outer edges of the
mounting brackets extend the width to 19 in. (48.3 cm). The spacing of rails and adjacent
racks must also allow for the clearances around the router and rack.
The mounting holes for connecting the mounting brackets to the chassis are spaced
0.984 in. (25 mm) apart.
The chassis height of 37.45 in. (95.1 cm) is approximately 21.4 U. A U is the standard rack
unit defined in Cabinets, Racks, Panels, and Associated Equipment (document number
EIA-310-D) published by the Electronics Industry Association. You can stack two routers
in a rack that has at least 42.8 U (74.9 in. or 1.90 m) of usable vertical space.
The rack must be strong enough to support the weight of the fully configured router, up
to 606 lb (275 kg). If you stack two fully configured routers in one rack, it must be capable
of supporting about 1212 lb (550 kg).
http://www.ecianow.org/ ).
http://www.etsi.org
Copyright © 2018, Juniper Networks, Inc.
). Use approved