Removing The T4000 Installation Handle; Figure 39: Installing The Router In A Four-Post Rack - Juniper T4000 Hardware Manual

T4000 Core Router Hardware Guide

Removing the T4000 Installation Handle

144

Figure 39: Installing the Router in a Four-Post Rack

NOTE: For an illustration of the mounting hardware required for an
open-frame rack, see
Open-Frame Rack" on page
After you have installed the router, remove the installation handle:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws on the installation handle completely.
2.
Remove the handle from the chassis.
3.
"Installing the T4000 Mounting Hardware for an
133.
Copyright © 2018, Juniper Networks, Inc.