Copying Junos Os To The Compactflash Card In A T1600 Re-C1800 Routing Engine; Figure 115: Installing A Compactflash Card - Juniper T4000 Hardware Manual

T4000 Core Router Hardware Guide

Copying Junos OS to the CompactFlash Card in a T1600 RE-C1800 Routing Engine

Related
Documentation
288
Reinstall the Routing Engine cover. Using a Phillips (+) screwdriver, number 2, tighten
4.
the screws on the corners of the cover to secure it to the Routing Engine.
From the master Routing Engine, power on the Routing Engine. Issue the
5.
system power-on other-routing-engine
NOTE: After you replace a CompactFlash card, the Routing Engine boots
from the solid-state disk (SSD). You may get an error message and be
prompted for a keystroke. After you press the keystroke, it might take up
to 10 minutes for the Routing Engine to reset and for the router to boot
from the SSD.

Figure 115: Installing a CompactFlash Card

After installing the CompactFlash card for the first time, you must copy the software
from the Routing Engine's solid-state disk (SSD) to the CompactFlash card.
To copy software to the CompactFlash card:
On the console or other management device connected to the Routing Engine, enter
1.
CLI operational mode and copy the currently running and active file system partitions
on the router to standby partitions on the CompactFlash card. Issue the
command.
snapshot partition
Wait until a message appears on the console confirming that the snapshot partition
2.
procedure is complete.
Issue the
request system reboot
3.
Issue the
show system boot-messages
4.
card is listed as the primary boot device. The output lists the devices mounted. The
CompactFlash card is located at
T4000 Routing Engine Description on page 33
T4000 RE-C1800 Routing Engine Description on page 34
T4000 RE-C1800 LEDs on page 35
command.
command to reboot the router's software.
command to verify that the CompactFlash
ad0 .
Copyright © 2018, Juniper Networks, Inc.
request
request system