Juniper T4000 Hardware Manual page 323

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
Back up the currently running and active file system partitions on the router to standby
5.
partitions that are not running. Issue the
Wait until a message appears on the console confirming that the snapshot procedure
6.
is complete.
Reboot the router's software again. Issue the
7.
Verify that the SSD is listed as the secondary boot device. The output lists the devices
8.
mounted. The SSD is located at
T4000 Routing Engine Description on page 33
T4000 RE-C1800 Routing Engine Description on page 34
T4000 RE-C1800 LEDs on page 35
T4000 Craft Interface LEDs
Prevention of Electrostatic Discharge Damage on page 423
Chapter 29: Replacing Host Subsystem Components
request system snapshot
request system reboot
. Issue the
ad1 show system boot-messages
command.
command.
command.
293