Installing The T4000 Rear Air Filter; Figure 100: Removing The Rear Air Filter Element - Juniper T4000 Hardware Manual

See Also

Installing the T4000 Rear Air Filter

Copyright © 2018, Juniper Networks, Inc.

Figure 100: Removing the Rear Air Filter Element

To install the rear air filter (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Holding the filter by the tabs, carefully push the filter all the way into the air filter slot.
2.
Holding the filter all the way in, push it to the right side of the slot until it is held in
3.
place behind the hooks.
Move the tabs to a vertical position.
4.
Chapter 28: Replacing Cooling System Components
Figure 101 on page 264):
263