Figure 85: Power Supply Covers - Juniper T4000 Hardware Manual

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
Verify that the power cabling is correct, that the power cables are not touching or
30.
blocking access to router components, and that they do not drape where people could
trip on them.
Install the clear plastic terminal jumper cover (labeled 2 in
31.
located in the terminal jumper kit (model number PWR-T-BUS-BAR-S) to protect
the terminal studs on the faceplate.
NOTE: You must use the terminal jumper cover provided in the terminal
jumper kit (model number PWR-T-BUS-BAR-S) to ensure there is no
access to the terminal jumpers and for proper cable alignment. The
terminal jumper cover (labeled 2 in
openings and is longer than the original clear plastic cover (labeled 1 in
Figure 85 on page

Figure 85: Power Supply Covers

1
Tools and Parts Required to Provide Power to the T4000 Router on page 185
Connecting DC Power to the T4000 Router (Six 60-A Inputs) on page 186
Connecting DC Power to the T4000 Router (Five 60-A Inputs) on page 190
Connecting DC Power to the T4000 Router (Four 60-A Inputs) on page 194
Powering On the T4000 Router on page 207
Configuring DC Power on a T4000 Router on page 213
Troubleshooting the T4000 Power System on page 363
T4000 DC Power Requirements on page 97
T4000 Power Management (Four 60-A Cables on a Six-Input DC Power Supply) on
page 103
Chapter 22: Connecting the Router to Power
Figure 85 on page
205) that has six cable openings.
2
Figure 85 on page 205)
205) has three cable
205