T4000 Core Router Hardware Guide
Removing the Center-Mounting Brackets from the Chassis
134
On the rear of each rack rail, partially insert a mounting screw into the lowest hole
1.
specified in
Table 76 on page 133
Install the large shelf on the rack. Rest the bottom slot of each flange on a mounting
2.
screw.
Partially insert screws into the open holes in the flanges of the large shelf.
3.
Tighten all the screws completely.
4.
Figure 34: Installing the Mounting Hardware for an Open-Frame Rack
Before front-mounting the router in an open-frame rack, you must remove the
center-mounting brackets from the chassis.
To remove the center-mounting brackets (see
Loosen the screws at the top and bottom of each bracket.
1.
for the large shelf.
Figure 35 on page
Copyright © 2018, Juniper Networks, Inc.
135):