Juniper T4000 Hardware Manual page 390

T4000 Core Router Hardware Guide
Start time
Uptime
360
2011-10-24 09:54:43 UTC
14 days, 19 hours, 58 minutes, 13 seconds
Verify that the FPC is properly seated in the midplane. Check that each ejector handle
3.
has been turned clockwise and is tight. Use a screwdriver to check that the screws
inside the ejector handles are tight.
Use the
show chassis fabric fpcs
4.
user@host> show chassis fabric fpcs
Fabric management FPC state:
FPC #4
PFE #0
SIB #0
Links ok
SIB #1
Plane enabled
SIB #2
Plane enabled
SIB #3
Plane enabled
SIB #4
Plane enabled
PFE #1
SIB #0
Links ok
SIB #1
Plane enabled
SIB #2
Plane enabled
SIB #3
Plane enabled
SIB #4
Plane enabled
FPC #6
PFE #0
SIB #0
Links ok
SIB #1
Plane enabled
SIB #2
Plane enabled
SIB #3
Plane enabled
SIB #4
Plane enabled
PFE #1
SIB #0
Links ok
SIB #1
Plane enabled
SIB #2
Plane enabled
SIB #3
Plane enabled
SIB #4
Plane enabled
FPC #7
command to check the status of an FPC.
Copyright © 2018, Juniper Networks, Inc.