Installing A T4000 Lcc-Cb; Figure 108: Removing An Lcc-Cb - Juniper T4000 Hardware Manual

T4000 Core Router Hardware Guide

Installing a T4000 LCC-CB

278
Place the LCC-CB on the antistatic mat.
7.
If you are not replacing the LCC-CB now, install a blank panel over the empty slot.
8.

Figure 108: Removing an LCC-CB

To install an LCC-CB (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Verify that the CHASSIS ID
2.
for your configuration. If you are installing the LCC-CB in a standalone router, the
switch must be set to
S
NOTE: See Setting the Chassis ID and M/S Switch on the LCC-CB in the TX
Matrix Plus Router Hardware Guide for instructions to set the switches
when installing the LCC-CB in a T4000 that is part of a routing matrix.
Carefully align the sides of the LCC-CB with the guides inside the chassis.
3.
Slide the LCC-CB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles, and press them inward to seat the LCC-CB.
5.
Figure 109 on page 280):
and M/S switches on the LCC-CB faceplate are set correctly
and the configuration switch must be set to
CHASSIS ID
Copyright © 2018, Juniper Networks, Inc.
M/S
.
0