Link Aggregation Setting - ZyXEL Communications GS1350 Series User Manual

Switching > Link Aggregation > Link Aggregation Status
Fig ure 252
The following table describes the labels in this screen.
Table 172 Switching > Link Aggregation > Link Aggregation Status
L ABEL
Group ID
Enabled Ports
Synchronized
Ports
Aggregator ID
Criteria
Status
49.4 L ink Ag g re g a tio n Se tting
Use the
L ink Ag g re g a tio n Se tting
of physical ports into one logical higher-capacity link. You may want to trunk ports if for example, it is
cheaper to use multiple lower-speed links than to under-utilize a high-speed, but more costly, single-port
link. However, the more ports you aggregate then the fewer available ports you have. A trunk group is
one logical link containing multiple ports.
Chapter 49 Switching
DESC RIPT IO N
This field displays the group ID to identify a trunk group, that is, one logical link containing multiple
ports.
These are the ports you have configured in the
The port numbers displays only when this trunk group is activated and there is a port belonging to
this group.
These are the ports that are currently transmitting data as one logical link in this trunk group.
Link Aggregator ID consists of the following: system priority, MAC address, key, port priority and
port number.
The ID displays only when there is a port belonging to this trunk group and LACP is also enabled
for this group.
This shows the outgoing traffic distribution algorithm used in this trunk group. Packets from the
same source and/or to the same destination are sent over the same link within the trunk.
means the Switch distributes traffic based on the packet's source MAC address.
src - m a c
means the Switch distributes traffic based on the packet's destination MAC address.
dst- m a c
means the Switch distributes traffic based on a combination of the packet's source
src - dst- m a c
and destination MAC addresses.
means the Switch distributes traffic based on the packet's source IP address.
src - ip
means the Switch distributes traffic based on the packet's destination IP address.
dst- ip
means the Switch distributes traffic based on a combination of the packet's source
src - dst- ip
and destination IP addresses.
This field displays how these ports were added to the trunk group. It displays:
• – if the ports are configured as static members of a trunk group.
Sta tic
• – if the ports are configured to join a trunk group via LACP.
L AC P
screen to enable static link. Link aggregation (trunking) is the grouping
GS1350 Series User's Guide
L ink Ag g re g a tio n
345
screen to be in the trunk group.