Technical Reference; Static Trunking Example - ZyXEL Communications GS1350 Series User Manual

Table 70 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP (continued)
L ABEL
*
LACP Timeout
Apply
Cancel
17.4 T e c hnic a l Re fe re nc e
This section provides technical background information on the topics discussed in this chapter.
17.4.1 Sta tic T runking Exa m ple
This example shows you how to create a static port trunk group for ports 2
1
Ma ke yo ur physic a l c o nne c tio ns
are connected to the same destination. The following figure shows ports 2
switch .
B
Trunking Example
Fig ure 122
2
C o nfig ure sta tic trunking –
this screen activate trunk group
the ports that should belong to this group as shown in the figure below. Click
Chapter 17 Link Aggregation
DESC RIPT IO N
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Timeout is the time interval between the individual port exchanges of LACP packets in order to
check that the peer port in the trunk group is still up. If a port does not respond after three tries,
then it is deemed to be "down" and is removed from the trunk. Set a short timeout (one second)
for busy trunked links to ensure that disabled ports are removed from the trunk group as soon as
possible.
Select either 1 second or 30 seconds.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
- make sure that the ports that you want to belong to the trunk group
Physical Connections
–
Click
Adva nc e d Applic a tio n
, select the traffic distribution algorithm used by this group and select
T 1
GS1350 Series User's Guide
link on the top navigation panel to save
Sa ve
>
L ink Ag g re g a tio n
161
5.
–
5 on switch connected to
–
A
>
L ink Ag g re g a tio n Se tting
when you are done.
Apply
. In