Switch Configuration - ZyXEL Communications GS1350 Series User Manual

I can see the
L o g in
1
Make sure you have entered the user name and password correctly. The default user name is
and the default password is
2
You may have exceeded the maximum number of concurrent Telnet sessions. Close other Telnet
sessions or try connecting again later.
Check that you have enabled logins for HTTP or Telnet. If you have configured a secured client IP
address, your computer's IP address must match it. Refer to the chapter on access control for details.
3
Disconnect and re-connect the cord to the Switch.
4
If this does not work, you have to reset the device to its factory defaults. See
Pop-up Windows, JavaScripts and Java Permissions
In order to use the Web Configurator you need to allow:
• Web browser pop-up windows from your device.
• JavaScripts (enabled by default).
• Java permissions (enabled by default).
There is unauthorized access to my Switch via telnet, HTTP and SSH.
To avoid unauthorized access, configure the secured client setting in the
>
C o ntro l Re m o te Ma na g e m e nt
Computers not belonging to the secured client set cannot get permission to access the Switch.
53.3 Switc h C o nfig ura tio n
I lost my configuration settings after I restart the Switch.
Make sure you save your configuration into the Switch's non-
volatile memory each time you make changes. Click
top right corner of the Web Configurator to save the
configuration permanently. See also
your configuration.
Chapter 53 Troubleshooting
screen, but I cannot log in to the Switch.
. These fields are case-sensitive, so make sure [Caps Lock] is not on.
1234
screen for telnet, HTTP and SSH (see
Section 33.2.2 on page 259
GS1350 Series User's Guide
at the
Sa ve
for more information about how to save
384
Section 4.8 on page
>
Ma na g e m e nt Ac c e ss
Section 34.6 on page 277).
,
a dm in
67.