Link Aggregation Status - ZyXEL Communications GS1350 Series User Manual

operational port fails, then one of the "standby" ports become operational without user intervention.
Please note that:
• You must connect all ports point-to-point to the same Ethernet switch and configure the ports for
LACP trunking.
• LACP only works on full-duplex links.
• All ports in the same trunk group must have the same media type, speed, duplex mode and flow
control settings.
Configure trunk groups or LACP before you connect the Ethernet switch to avoid causing network
topology loops.
L ink Ag g re g a tio n ID
LACP aggregation ID consists of the following information
Table 66 Link Aggregation ID: Local Switch
SYST EM PRIO RIT Y
0000
Table 67 Link Aggregation ID: Peer Switch
SYST EM PRIO RIT Y
0000
17.2 L ink Ag g re g a tio n Sta tus
Click
Adva nc e d Applic a tio n
screen displays by default. See
Advanced Application > Link Aggregation Status
Fig ure 119
1. Port Priority and Port Number are 0 as it is the aggregator ID for the trunk group, not the individual port.
Chapter 17 Link Aggregation
MAC ADDRESS KEY
00-00-00-00-00-00 0000
MAC ADDRESS KEY
00-00-00-00-00-00 0000
>
L ink Ag g re g a tio n
Section 17.1 on page 156
GS1350 Series User's Guide
157
1
:
PO RT PRIO RIT Y
00
PO RT PRIO RIT Y
00
in the navigation panel. The
for more information.
PO RT NUMBER
0000
PO RT NUMBER
0000
L ink Ag g re g a tio n Sta tus