Save Configuration; Reboot System - ZyXEL Communications GS1350 Series User Manual

1
In the
Ma inte na nc e
Switch configuration information you configured and return to the Zyxel default configuration settings.
2
Click to reset all Switch configurations to the Zyxel default configuration settings.
O K
Erase Running-Configuration: Confirmation
Fig ure 191
3
In the Web Configurator, click the
effect. If you want to access the Switch Web Configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1).
33.2.2 Sa ve C o nfig ura tio n
Click
C o nfig 1
These configurations are set up according to your network environment.
Click
C o nfig 2
These configurations are set up according to your network environment.
Click
C usto m De fa ult
on the Switch.
Note: If a customized default file was not saved, clicking
default configuration on the Switch.
Alternatively, click
to the current configuration.
Note: Clicking the
unsaved changes are erased after you reboot the Switch.
33.2.3 Re b o o t Syste m
Re b o o t Syste m
to load configuration one (
default configuration when you reboot. Follow the steps below to reboot the Switch.
1
In the
Ma inte na nc e
configuration file. The following screen displays.
Reboot System: Confirmation
Fig ure 192
Chapter 33 Maintenance
screen, click the
C lic k He re
Sa ve
to save the current configuration settings permanently to
to save the current configuration settings permanently to
to save the current configuration settings permanently to a customized default file
on the top right-hand corner in any screen to save the configuration changes
Sa ve
or button does NOT save the changes permanently. All
Apply Add
allows you to restart the Switch without physically turning the power off. It also allows you
), configuration two (
C o nfig 1
screen, click a configuration button next to
GS1350 Series User's Guide
button next to
Era se Running - C o nfig ura tio n
button in the top of the screen to make the changes take
C usto m De fa ult
C o nfig 2
Re b o o t Syste m
259
on the Switch.
C o nfig ura tio n 1
on the Switch.
C o nfig ura tio n 2
loads the factory
), a or the factory
C usto m De fa ult
to reboot and load that
to clear all