Table 169 Port > PoE Setup > PoE Setup (continued)
L ABEL
LLDP Power Via
MDI
Apply
Cancel
48.5 Po rt Se tup
Use this screen to configure Switch port settings. Click
the configuration screen.
Fig ure 250
DESC RIPT IO N
Select this to have the Switch negotiate PoE power with the PD connected to the port by
transmitting LLDP Power Via MDI TLV frames. This helps the Switch allocate less power to the PD on
this port. The connected PD must be able to request PoE power through LLDP.
The Power Via MDI TLV allows PoE devices to advertise and discover the MDI power support
capabilities of the sending port on the remote device.
•
Port Class
•
MDI Supported
•
MDI Enabled
•
Pair Controllable
•
PSE Power Pairs
•
Power Class
Click
to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click
to begin configuring this screen afresh.
C a nc e l
Port > Port Setup
GS1350 Series User's Guide
Chapter 48 Port
>
Po rt
Po rt Se tup
340
link on the top navigation panel to save
Sa ve
in the navigation panel to display