ZyXEL Communications GS1350 Series User Manual page 369

Encryption protects the contents of the SNMP messages. When the contents of the SNMP messages are
encrypted, only the intended recipients can read them.
Click >
Se c urity Ac c e ss C o ntro l
Security > Access Control > SNMP > SNMP
Fig ure 272
The following table describes the labels in this screen.
Table 188 Security > Access Control > SNMP > SNMP
L ABEL DESC RIPT IO N
General Setting Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (
(
v3v2c
SNMP version 2c is backwards compatible with SNMP version 1.
Get Community Enter the
requests from the management station.
The
G e t C o m m unity
Set Community Enter the
management station.
The
Se t C o m m unity
Trap Community Enter the
manager.
The
T ra p C o m m unity
Trap Destination Use this section to configure where to send SNMP traps from the Switch.
Index This field displays the index number of an entry.
Version Specify the version of the SNMP trap messages.
IP Enter the IP addresses of up to 4 managers to send your SNMP traps to.
Port Enter the port number upon which the manager listens for SNMP traps.
Chapter 51 Security
> > to view the screen as shown.
SNMP SNMP
).
string, which is the password for the incoming Get- and GetNext-
G e t C o m m unity
string is only used by SNMP managers using SNMP version 2c or lower.
, which is the password for incoming Set- requests from the
Se t C o m m unity
string is only used by SNMP managers using SNMP version 2c or lower.
string, which is the password sent with each trap to the SNMP
T ra p C o m m unity
string is only used by SNMP managers using SNMP version 2c or lower.
GS1350 Series User's Guide
369
), SNMP version 3 ( ) or both
v2c v3