Link Aggregation Setting - ZyXEL Communications XS1930-12HP User Manual

Table 73 Advanced Application > Link Aggregation
LABEL
Synchronized
Ports
Aggregator ID
Criteria
Status

17.3 Link Aggregation Setting

Click Advanced Application > Link Aggregation > Link Aggregation Setting to display the screen shown
next. See Section 17.1 on page 160
Chapter 17 Link Aggregation
DESCRIPTION
These are the ports that are currently transmitting data as one logical link in this trunk group.
Link Aggregator ID consists of the following: system priority, MAC address, key, port priority and
port number. Refer to Link Aggregation ID on page 161
The ID displays only when there is a port belonging to this trunk group and LACP is also enabled
for this group.
This shows the outgoing traffic distribution algorithm used in this trunk group. Packets from the
same source and/or to the same destination are sent over the same link within the trunk.
src-mac means the Switch distributes traffic based on the packet's source MAC address.
dst-mac means the Switch distributes traffic based on the packet's destination MAC address.
src-dst-mac means the Switch distributes traffic based on a combination of the packet's source
and destination MAC addresses.
src-ip means the Switch distributes traffic based on the packet's source IP address.
dst-ip means the Switch distributes traffic based on the packet's destination IP address.
src-dst-ip means the Switch distributes traffic based on a combination of the packet's source
and destination IP addresses.
This field displays how these ports were added to the trunk group. It displays:
• Static - if the ports are configured as static members of a trunk group.
• LACP - if the ports are configured to join a trunk group via LACP.
for more information on link aggregation.
XS1930 Series User's Guide
for more information on this field.
162