ZyXEL Communications GS1350 Series User Manual page 312

The following table describes the labels in this screen.
Table 155 Management > Configure Clone
L ABEL DESC RIPT IO N
Enter the source port under the
Source/
Destination
Enter the destination port or ports under the
Port to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a dash.
Example:
indicates that ports 2, 4 and 6 are the destination ports.
2, 4, 6
indicates that ports 2 through 6 are the destination ports.
2–6
Basic Setting Select * to apply all settings to the port. Use this first to select the common settings and then
remove the settings you do not want copied.
Select which port settings (you configured in the
destination ports.
Advanced Select which port settings (you configured in the
Application to the destination ports.
Apply Click
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
Chapter 42 Configure Clone
So urc e
to save your changes to the Switch's run-time memory. The Switch loses these
to begin configuring this screen afresh.
GS1350 Series User's Guide
312
label. This port's attributes are copied.
label. These are the ports which are going
De stina tio n
menus) should be copied to the
Ba sic Se tting
Adva nc e d Applic a tio n
link on the top navigation panel to save
Sa ve
menus) should be copied