Technical Reference; Cluster Member Switch Management - ZyXEL Communications GS1350 Series User Manual

Table 150 Management > Cluster Management > Configuration (continued)
L ABEL
Cancel
Clustering
Candidate
List
Password
Add
Cancel
Refresh
The next summary table shows the information for the clustering members configured.
Index
MacAddr
Name
Model
Remove
Cancel
38.4 T e c hnic a l Re fe re nc e
This section provides technical background information on the topics discussed in this chapter.
38.4.1 C luste r Me m b e r Switc h Ma na g e m e nt
Go to the
C luste ring Ma na g e m e nt Sta tus
hyperlink from the list of members to go to that cluster member switch's Web Configurator home page.
This cluster member Web Configurator home page and the home page that you would see if you
accessed it directly are different.
Chapter 38 Cluster Management
DESC RIPT IO N
Click to begin configuring this screen afresh.
C a nc e l
The following fields relate to the switches that are potential cluster members.
A list of suitable candidates found by auto-discovery is shown here. The switches must be
directly connected. Directly connected switches that are set to be cluster managers will not
be visible in the
C luste ring C a ndida te
VLAN group will not be visible in the
Each cluster member's password is its Web Configurator password. Select a member in the
list and then enter its Web Configurator password. If that switch
C luste ring C a ndida te
administrator changes the Web Configurator password afterwards, then it cannot be
managed from the
C luste r Ma na g e r
screen.
Ma na g e m e nt Sta tus
If multiple devices have the same password then hold [SHIFT] and click those switches to
select them. Then enter their common Web Configurator password.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Add
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
Click to perform auto-discovery again to list potential cluster members.
Re fre sh
This is the index number of a cluster member switch.
This is the cluster member switch's hardware MAC address.
This is the cluster member switch's
This is the cluster member switch's model name.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click the button to remove the selected cluster member switches from the cluster.
Re m o ve
Click to begin configuring this screen afresh.
C a nc e l
screen of the cluster manager switch and then select an
GS1350 Series User's Guide
302
list. Switches that are not in the same management
list.
C luste ring C a ndida te
. Its is displayed as
Sta tus
link on the top navigation panel to
Sa ve
.
Syste m Na m e
in the
Erro r C luste r
Inde x