ZyXEL Communications GS1350 Series User Manual page 325

The following table describes the fields in this screen.
Table 163 Summary > Neighbor Detail
L ABEL DESC RIPT IO N
Search Ports... Enter the port number and click the magnify icon to view and manage the neighboring
device connected to the port.
Flush All Click the
the Switch.
Port This shows the port of the Switch, on which the neighboring device is discovered.
Flush Click the
ports.
Port Name This shows the port description of the Switch.
PD Health This shows the status of auto PD recovery on this port.
•
•
•
•
Note: The status will NOT be updated instantaneously after enabling or disabling
Link Speed This shows the speed (either
duplex (
any device.
PoE Draw (W) This shows the consumption that the neighboring device connected to this port draws from
the Switch. This allows you to plan and use within the power budget of the Switch.
Action Click the
again.
Note: The Switch must support power sourcing (PSE) or the network device is a
Bandwidth Tx/Rx (%) This field displays the percentage of bandwidth usage on this port as a percentage of the
L ink Spe e d
CRC This shows the number of packets received with CRC (Cyclic Redundant Check) errors.
Extend Range This shows whether PoE range is extended up to 250 meters for the port on this Switch.
PD Failed Count
Note: Make sure Auto PD Recovery is enabled on your Switch (see
This shows the number of times the Switch attempts to restart the PD on the port.
The
System Name This shows the system name of the neighbor device.
Port This shows the number of the neighbor device's port which is connected to the Switch.
Model This shows the model name of the neighbor device. This field will show "
do not support the ZON utility.
IP This shows the IPv4 or IPv6 address of the neighbor device. The IPv4 or IPv6 address is a
hype r link
Configurator.
Chapter 45 Surveillance Mode
button to remove information about neighbors learned on all the ports of
Flush All
button to remove information about neighbors learned on the selected
Flush
Red: The Switch failed to get information from the PD connected to the port using LLDP,
or the connected PD did not respond to the Switch's ping requests.
Yellow: The Switch is restarting the connected PD by turning the power off and turning it
on again.
Green: The Switch successfully discovered the connected PD using LLDP or ping.
–: Auto PD Recovery is not enabled on the Switch and the port, or the Switch does not
supply power to the connected PD.
the switch in the
Ac tive
configured
Re sum e Po lling Inte rva l (se c )
10M
for full duplex or for half). This field displays
F H
button to turn OFF the power of the neighbor device and turn it back ON
Re b o o t
powered device (PD).
.
on page 333).
will reset after clicking the
PD Fa ile d C o unt
that you can click to log into and manage the neighbor device through its Web
GS1350 Series User's Guide
325
>
Po rt Auto PD Re c o ve ry
has lapsed.
for 10Mbps, for 100Mbps, or
100M
if the port is not connected to
Do wn
button.
Flush
screen. It will wait until the
for 1 Gbps) and the
1G
Section 48.2
" for devices that
- -