ZyXEL Communications GS1350 Series User Manual page 293

The following table describes the labels in this screen.
Table 145 Management > Diagnostic
L ABEL DESC RIPT IO N
Ping Test
IPv4 Select this option if you want to ping an IPv4 address, and select
number of the VLAN to which the Switch is to send ping requests. Otherwise, select
ping requests to all VLANs on the Switch.
IPv6 Select this option if you want to ping an IPv6 address. You can also select
the ID number of the VLAN to which the Switch is to send ping requests. Otherwise, select
send ping requests to all VLANs on the Switch.
IP Address/Host Type the IP address or host name of a device that you want to ping in order to test a
Name
connection.
Click
Count Enter the number of ICMP Echo Request (ping) messages the Switch continuously sends.
Trace Route Test
IPv4 Select this option if you want to trace the route packets take to a device with an IPv4
address, and select
the path. Otherwise, select
Note: The device to which you want to run a traceroute must belong to the VLAN
IPv6 Select this option if you want to trace the route packets take to a device with an IPv6
address.
IP Address/Host Enter the IP address or host name of a device to which you want to perform a traceroute.
Name
Click
path a packet takes to the specified device.
TTL Enter the Time To Live (TTL) value for the ICMP Echo Request packets. This is to set the
maximum number of the hops (routers) a packet can travel through. Each router along the
path will decrement the TTL value by one and forward the packets. When the TTL value
becomes zero and the destination is not found, the router drops the packets and informs the
sender.
Wait Time Specify how many seconds the Switch waits for a response to a probe before running
another traceroute.
Queries Specify how many times the Switch performs the traceroute function.
Ethernet Port Test Enter a port number and click
Port This is the number of the physical Ethernet port on the Switch.
Cable Diagnostics Enter a port number and click
connections on the specified ports. The following fields display when you diagnose a port.
Note: This feature is limited to within 100 meters only.
Port This is the number of the physical Ethernet port on the Switch.
Channel An Ethernet cable usually has 4 pairs of wires. A 10BASE-T or 100BASE-TX port only use and test
2 pairs, while a 1000BASE-T port requires all 4 pairs.
This displays the descriptive name of the wire-pair in the cable.
Chapter 35 Diagnostic
to have the Switch ping the IP address.
Ping
to specify the ID number of the VLAN on which the Switch traces
vla n
to trace the path on any VLAN.
–
you specify here.
to have the Switch perform the traceroute function. This determines the
T ra c e Ro ute
Po rt T e st
Dia g no se
GS1350 Series User's Guide
293
vla n
to perform an internal loopback test.
to perform a physical wire-pair test of the Ethernet
to specify the ID
to send
–
and specify
vla n
to
–