ZyXEL Communications GS1350 Series User Manual page 85

Status > Neighbor
Fig ure 66
The following table describes the fields in the above screen.
Table 22 Status > Neighbor
L ABEL DESC RIPT IO N
Port This shows the port of the Switch, on which the neighboring device is discovered.
Port Name This shows the port description of the Switch.
PD Health This shows the status of auto PD recovery on this port. See
more information on how to enable auto PD recovery on the Switch and ports.
•
•
•
•
Note: The status will NOT be updated instantaneously after enabling or disabling
Link This shows the speed (either
duplex (
any device.
PoE Draw (W) This shows the consumption that the neighboring device connected to this port draws from
the Switch. This allows you to plan and use within the power budget of the Switch.
System Name This shows the system name of the neighbor device.
IPv4 This shows the IPv4 address of the neighbor device. The IPv4 address is a
can click to log into and manage the neighbor device through its Web Configurator.
IPv6 This shows the IPv6 address of the neighbor device. The IPv6 address is a
can click to log into and manage the neighbor device through its Web Configurator.
PWR Cycle Click the
again. A count down button (from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
Chapter 7 Status
Red: The Switch failed to get information from the PD connected to the port using LLDP,
or the connected PD did not respond to the Switch's ping requests.
Yellow: The Switch is restarting the connected PD by turning the power off and turning it
on again.
Green: The Switch successfully discovered the connected PD using LLDP or ping.
: Auto PD Recovery is not enabled on the Switch and the port, or the Switch does not
–
supply power to the connected PD.
the switch in the
Ac tive
(see Section 28.2 on page 230
Re sum e Po lling Inte rva l (se c )
10M
for full duplex or for half). This field displays
F H
button to turn OFF the power of the neighbor device and turn it back ON
C yc le
powered device (PD).
GS1350 Series User's Guide
85
Section 28.2 on page 230
>
Adva nc e d Applic a tio n
for details). It will wait until the configured
has lapsed.
for 10Mbps, for 100Mbps, or
100M
if the port is not connected to
Do wn
for
screen
Auto PD Re c o ve ry
for 1 Gbps) and the
1G
that you
hype r link
that you
hype r link