Configure Snmp Trap Group - ZyXEL Communications GS1350 Series User Manual

Table 188 Security > Access Control > SNMP > SNMP (continued)
L ABEL
Username
Apply
Cancel
51.5 C o nfig ure SNMP T ra p G ro up
The Switch sends traps to an SNMP manager when an event occurs. From the
to view the screen as shown. Use the
G ro up
should be sent to each SNMP manager.
Fig ure 273
The following table describes the labels in this screen.
Table 189 Security > Access Control > SNMP > Trap Group
L ABEL
Trap Destination IP
Type
Chapter 51 Security
DESC RIPT IO N
Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
This username must match an existing account on the Switch (configured in the
> >
Ac c e ss C o ntro l
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
Security > Access Control > SNMP > Trap Group
DESC RIPT IO N
Select one of your configured trap destination IP addresses. These are the IP addresses of the
SNMP managers. You must first configure a trap destination IP address in the
screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
GS1350 Series User's Guide
> screen).
SNMP Use r
screen to specify the types of SNMP traps that
T ra p G ro up
370
link on the top navigation panel to
Sa ve
screen, click
SNMP
SNMP Se tting
Ma na g e m e nt
T ra p