Ipv6 Interface Setup - ZyXEL Communications GS1350 Series User Manual

Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
Fig ure 86
The following table describes the labels in this screen.
Table 40 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
L ABEL
IPv6 Hop Limit
ICMPv6 Rate
Limit Bucket
Size
ICMPv6 Rate
Limit Error
Interval
Apply
Cancel
Clear
8.10.5 IPv6 Inte rfa c e Se tup
Use this screen to turn on or off an IPv6 interface and enable stateless auto-configuration on it. Click the
link next to
IPv6 Inte rfa c e Se tup
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Interface Setup
Fig ure 87
Chapter 8 Basic Setting
DESC RIPT IO N
Specify the maximum number of hops (from 1 to 255) in router advertisements. This is the
maximum number of hops on which an IPv6 packet is allowed to transmit before it is discarded by
an IPv6 router, which is similar to the TTL field in IPv4.
Specify the maximum number of ICMPv6 error messages (from 1 to 200) which are allowed to
transmit in a given time interval. If the bucket is full, subsequent error messages are suppressed.
Specify the time period (from 0 to 2147483647 milliseconds) during which ICMPv6 error messages
of up to the bucket size can be transmitted. 0 means no limit.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
Click to reset the fields to the factory defaults.
C le a r
in the
IPv6 C o nfig ura tio n
GS1350 Series User's Guide
link on the top navigation panel to save
Sa ve
screen to display the screen as shown next.
112