ZyXEL Communications GS1350 Series User Manual page 178

Advanced Application > AAA > RADIUS Server Setup
Fig ure 133
The following table describes the labels in this screen.
Table 78 Advanced Application > AAA > RADIUS Server Setup
L ABEL DESC RIPT IO N
Authentication Use this section to configure your RADIUS authentication settings.
Server
Mode This field is only valid if you configure multiple RADIUS servers.
Select
if the RADIUS server does not respond then the Switch tries to authenticate with the second
RADIUS server.
Select
requests to.
Timeout Specify the amount of time in seconds that the Switch waits for an authentication request
response from the RADIUS server.
If you are using
then the timeout value is divided between the two RADIUS servers. For example, if you set the
timeout value to 30 seconds, then the Switch waits for a response from the first RADIUS server for
15 seconds and then tries the second RADIUS server.
Index This is a read-only number representing a RADIUS server entry.
IP Address Enter the IP address of an external RADIUS server in dotted decimal notation.
UDP Port The default port of a RADIUS server for authentication is
unless your network administrator instructs you to do so.
Chapter 22 AAA
and the Switch tries to authenticate with the first configured RADIUS server,
inde x- prio rity
to alternate between the RADIUS servers that it sends authentication
ro und- ro b in
for your authentication and you are using two RADIUS servers
inde x- prio rity
GS1350 Series User's Guide
178
. You need not change this value
1812