Switch Lockout; Reset The Switch; Restore Button; Restore Custom Default - ZyXEL Communications GS1350 Series User Manual

Note: Use the
4.7 Switc h L o c ko ut
You could block yourself (and all others) from managing the Switch if you do one of the following:
1
Delete the management VLAN (default is VLAN 1).
2
Delete all port-based VLANs with the CPU port as a member. The "CPU port" is the management port of
the Switch.
3
Filter all traffic to the CPU port.
4
Disable all ports.
5
Misconfigure the text configuration file.
6
Forget the password and/or IP address.
7
Prevent all services from accessing the Switch.
8
Change a service port number but forget it.
Note: Be careful not to lock yourself and others out of the Switch.
4.8 Re se t the Switc h
If you lock yourself (and others) from the Switch or forget the administrator password, you will need to
reload the factory-default configuration file or reset the Switch back to the factory defaults.
4.8.1 Re sto re Butto n
Press the
REST O RE
the factory default file. See
4.8.2 Re sto re C usto m De fa ult
Press the
REST O RE
saved custom default file. See
4.8.3 Re b o o t the Switc h
Press the
RESET
more information about the LED behavior.
link when you are done with a configuration session.
Sa ve
button for more than 7 seconds to have the Switch automatically reboot and restore
Section 3.3 on page 39
button for 3 to 7 seconds to have the Switch automatically reboot and restore the last-
Section 3.3 on page 39
button to reboot the Switch without turning the power off. See
GS1350 Series User's Guide
for more information about the LED behavior.
for more information about the LED behavior.
67
Section 3.3 on page 39 for