Link Aggregation Control Protocol - ZyXEL Communications GS1350 Series User Manual

Table 173 Switching > Link Aggregation > Link Aggregation Setting (continued)
L ABEL
Apply
Cancel
49.5 L ink Ag g re g a tio n C o ntro l Pro to c o l
When you enable LACP link aggregation on a port, the port can automatically negotiate with the ports
at the remote end of a link to establish trunk groups. LACP also allows port redundancy, that is, if an
operational port fails, then one of the "standby" ports become operational without user intervention.
Click
Switc hing
See Dynamic Link Aggregation on page 156
Switching > Link Aggregation > Link Aggregation Control Protocol
Fig ure 254
Chapter 49 Switching
DESC RIPT IO N
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
> >
L ink Ag g re g a tio n L ink Ag g re g a tio n C o ntro l Pro to c o l
GS1350 Series User's Guide
link on the top navigation panel to save
Sa ve
for more information on dynamic link aggregation.
347
to display the screen shown next.