Enable Or Disable Sending Of Snmp Traps On A Port - ZyXEL Communications GS1350 Series User Manual

Table 189 Security > Access Control > SNMP > Trap Group (continued)
L ABEL
Options
Apply
Cancel
51.6 Ena b le o r Disa b le Se nding o f SNMP T ra ps o n a Po rt
Click
Se c urity
set whether a trap received on the ports would be sent to the SNMP manager.
Security > Access Control > SNMP > Trap Group Port
Fig ure 274
The following table describes the labels in this screen.
Table 190 Security > Access Control > SNMP > Trap Group Port
L ABEL
Option
Port
Chapter 51 Security
DESC RIPT IO N
Select the individual SNMP traps that the Switch is to send to the SNMP station.
The traps are grouped by category. Selecting a category automatically selects all of the
category's traps. Clear the check boxes for individual traps that you do not want the Switch
to send to the SNMP station. Clearing a category's check box automatically clears all of the
category's trap check boxes (the Switch only sends traps from selected categories).
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
> >
Ac c e ss C o ntro l SNMP
DESC RIPT IO N
Select the trap type you want to configure here.
This field displays a port number.
GS1350 Series User's Guide
> to view the screen as shown. Use this screen to
T ra p G ro up Po rt
371
link on the top navigation panel to
Sa ve