Link Aggregation Control Protocol - ZyXEL Communications GS1350 Series User Manual

17.3.1 L ink Ag g re g a tio n C o ntro l Pro to c o l
Click
Adva nc e d Applic a tio n
shown next. See
aggregation.
Fig ure 121
The following table describes the labels in this screen.
Table 70 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
L ABEL
Link
Aggregation
Control
Protocol
Active
System Priority
Group ID
LACP Active
Port
Chapter 17 Link Aggregation
>
L ink Ag g re g a tio n
Dynamic Link Aggregation on page 156
Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
DESC RIPT IO N
Note: Do NOT configure this screen unless you want to enable dynamic link
aggregation.
Select this check box to enable Link Aggregation Control Protocol (LACP).
LACP system priority is a number between 1 and 65535. The switch with the lowest system priority
(and lowest port number if system priority is the same) becomes the LACP "server". The LACP
"server" controls the operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority
level.
The field identifies the link aggregation group, that is, one logical link containing multiple ports.
Select this option to enable LACP for a trunk.
This field displays the port number.
GS1350 Series User's Guide
>
L ink Ag g re g a tio n Se tting
for more information on dynamic link
160
> to display the screen
L AC P